Table of Contents
Advertisement
BIT SWITCHES
BIT SWITCH 4
Bit
Function
0
Not used
1
RTI and CSI
programming function
0: Enabled
1: Disabled
2
Monitor speaker during
communication
0: Up to phase B
1: All the time
3
Automatic new polling
file list printout
0: Enabled
1: Disabled
4
Automatic new file list
printout
0: Enabled
1: Disabled
5
Automatic Tx report
printout
0: Enabled
1: Disabled
6
TCR data after printout
0: Keep
1: Delete
7
Automatic TCR printout
0: Automatic
1: Disabled
1: Function 24 (RTI) and 26 (CSI) are not accessible.
When Czech Rep. or Hungary is selected, this bit is
automatically set to "1", so that the users cannot
program the RTI and CSI by themselves (PTT
requirement).
To program the RTI and CSI, change this bit to "0",
program them, then change this bit back to "1".
0: The monitor speaker is on up to the following point.
TX - before DCS
RX - after DIS
1: Used for testing. The monitor speaker is on all
through the communication.
Be sure to reset this bit after test communications.
Same as the Function 48 (New Poll Report) setting.
Same as the Function 48 (New File Report) setting.
Same as the Function 48 (Tx Report) setting.
1: Communication records for TCR are deleted after the
TCR is printed.
Same as the Function 48 (TCR Report) setting.
0: The TCR is printed automatically after every 35
communications.
1: The TCR is not printed automatically. The oldest
communication record will be overwritten.
4-12
31 March, 1997
Comments
Advertisement
Table of Contents
