Table of Contents
Advertisement
EXTERIOR
— INNER COVER —
[A]
H905R506.cdr
[H]
1. Remove the document guide assembly [A] as shown.
2. Remove the top cover assembly if it has not been removed (see section 1.1.1).
3. Gently slide the print head carriage [B] to the left end, remove the cable
supporter [C], and release the flat cables [D] from the hooks.
4. Remove the inner cover [E] (4 screws).
NOTE: 1) Release the hooks [F] and [G] at the front edge of the inner cover.
2) Adjust the position of blue lever [H] so it does not interfere with the inner
cover.
3) At assembly, be sure that the lower edge of the inner cover [I] goes
under the carriage guide rail [J], and the flat cables [D] and the cable
supporter [C] are put back correctly. Also, check that the carriage
moves smoothly after assembly.
[B]
H905R507.cdr
H905R508.cdr
6-4
31 March, 1997
[C]
[D]
[E]
[G]
[F]
[I]
[J]
Advertisement
Table of Contents
