Table of Contents
Advertisement
31 March, 1997
[H]
[A]
8. Insert the shaft [A] into the opening in the carriage.
9. Insert the right end of the shaft into the opening [G] in the right frame, then
insert the left end into the opening [H] in the left frame. Do not lock them yet.
10. Lock the left end [H] of the shaft.
11. Be sure that the encoder [D] goes into the sensor slot [I] under the carriage
and that the carriage is correctly placed on the guide rail [J], then lock the right
end of the shaft.
12. Insert the carriage drive belt to the belt holders on the carriage.
13. Replace the inner cover and the top cover.
14. Turn on the machine and align the print head (function 88).
15. Make some test prints.
[J]
H905R525.cdr
6-15
PRINTER ENGINE
[I]
[G]
[D]
Advertisement
Table of Contents
