Restoring Default User Settings; Viewing System Information - RADVision SCOPIA XT5000 Series User Manual

Restoring Default User Settings

You can change the default settings of the system to adapt them to your work requirements. This
procedure explains how to restore the default settings if necessary. You can restore the default
settings at any time.
Procedure
Step 1
Access the SCOPIA XT Series web interface.
Step 2
Select the User Settings tab.
Step 3
Select Load default values.
Step 4
Select General.
Step 5
Select the Restore default button.
The default settings are restored.

Viewing System Information

You can view the following system information if your system is not currently in a call:
•
•
•
•
Note:
If you need the system serial number, you can also look on the label at the back of the XT Codec
Unit.
RADVISION | User Guide for SCOPIA XT5000 Series Version 3.0
software version
user code
IP addresses
serial number
Getting Started | 17