Removing The Expansion Board Assembly - HP Compaq SP700 Reference Manual

6-8 Hardware Upgrade Preparations
Removing the Expansion Board
Assembly
The expansion board assembly has expansion board slots on both the top and the
bottom of the assembly. To remove the expansion board assembly:
1.
2.
3.
Figure 6-4. Removing the expansion board assembly
4.
Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
Remove the side access panel.
Refer to the following illustration to remove the expansion board
assembly.
Reassemble the workstation and connect the power cord to the grounded
AC outlet and to the workstation.
IMPORTANT: After connecting the power cord to the grounded AC outlet
and to the workstation, DO NOT turn the power button on if the Power LED is
a steady amber color. A steady amber color indicates that the expansion
board assembly is not seated properly. Disconnect the power cord and reseat
the expansion board assembly.
IMPORTANT: When replacing the side access panel, be sure to tighten all
four thumbscrews.