Expansion connector board
Description
HDMI expansion connector board
Serial port expansion connector board
DisplayPort expansion connector board
An expansion board can be installed near the back of the system board that provides an additional connector
on the rear I/O panel. The board is secured with two screws and connects to the a connector on the system
board.
To remove the expansion connector board:
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the fan
4.
Remove the heat sink
5.
Remove the hard drive
6.
Remove the drive cage
7.
Remove the two Phillips screws that secure the board to the system board.
8.
Lift to disengage the board from the system board connector, and then remove the expansion connector
board from the computer.
NOTE:
To install the expansion connector board, reverse the removal procedures.
44
Chapter 4 Removal and replacement procedures – desktop mini (DM) chassis
(Access panel on page
(Fan on page
35).
(Heat sink on page
(Hard drive on page
(Drive cage on page
The following image shows a serial port expansion board.
(Preparation for disassembly on page
19).
41).
23).
25).
18).