Identifying The Accelerated Graphics Port (Agp) Graphics Controller Expansion Slot; Installing And Removing An Agp Graphics Controller - HP Compaq SP700 Reference Manual

9-6 Expansion Boards
Identifying the Accelerated Graphics
Port (AGP) Graphics Controller
Expansion Slot
Your workstation also ships with an AGP expansion slot 1 on the system board.
The following figure shows the location of this slot.
Figure 9-4. Identifying the AGP graphics controller slot
Installing and Removing an AGP
Graphics Controller
To install the AGP graphics controller, remove the metal slot screw and cover,
insert the board in the AGP slot, and press firmly into place.
To remove the AGP graphics controller, hold the board at each end, then pull
up. Be sure to replace the metal slot screw and cover.
IMPORTANT: To ensure the board fits properly, be sure to use AGP
graphics controllers with ATX format brackets.
IMPORTANT: Be sure to press firmly on the board so that the whole
connector seats properly in the AGP slot. If you are installing a full length
expansion board, be sure to engage the card guide.
1