HP Compaq SP700 Reference Manual page 32

2-4 Compaq Setup and Diagnostic Software
Computer Setup Features
Enable and disable power LED blink in
suspend mode.
NOTE: This selection does not appear if the
energy saver mode is disabled.
Enable the Power-on Password. For more
information, see the section "Security
Management" in Chapter 3.
Enable and disable network server mode. For
more information, see the section "Security
Management" in Chapter 3.
NOTE: This selection appears only if a Power-
on Password is set.
Enable the Setup (administrator) Password.
For more information, see the section
"Security Management" in Chapter 3.
Enable/disable serial, parallel, and USB ports
and audio security
Set the Asset Tag and Ownership Tag. See
the section "Security Management" in
Chapter 3 for more information.
Set the keyboard locale setting (for example,
English or German) for the System ID entry
Enable/disable Network Service Boot
Enable/disable the SCSI controller order for
Compaq SCSI options. Enables the embedded
SCSI controller to boot before or after any
plug in adapters.
Continued
Task Computer Setup Selection
Select Power, then select Energy Saver
Options.
Select Security, then select Power-On
Password.
Select Security, then select Password
Options.
Select Security, then select Setup
Password.
Select Security, then select Device
Security.
Select Security, then select System IDs.
Select Security, then select System IDs.
Select Security, then select Network
Service Boot.
Select Storage, then select SCSI
Controller Order.
Continued