Communication Environment Setup - Canon imageCLASS MF4270 Reference Manual

Before Using the
Machine 1
Document and Paper
2
Copying
3
Sending and
Receiving 4
Printing and
Scanning
5
Network
6
Remote UI
7
System Manager
Settings
8
Maintenance
9
Troubleshooting
10
Appendix
11
Table of Contents
Index
10.
Press [ ] or [ ] to select the desired Ethernet
connection type, then press [OK].
<100 BASE-TX>: Establishes a 100Base-TX network connection.
<10 BASE-T>: Establishes a 10Base-T network connection.
11.
Press [Stop/Reset] to return to the standby
mode.
12.
Restart the machine.
Back Previous

Communication Environment Setup

■
To set up a configuration for communication between the machine
and computers on your network, use the following procedure.
SNMP
SNMP helps monitor the state of the machine and collects
information on it. The default setting is <ON>.
The following two items can be set:
<COMMUNITY NAME>:
Sets the SNMP community name. You can specify up to two
community names.
The default setting is <public> for COMMUNITY NAME 1.
<SNMP WRITABLE>:
Enables the computers on the network to access the machine and
modify its settings if this item is activated. You can specify this
setting for each community separately.
The default setting is <ON> for SNMP WRITABLE 1 and <OFF> for
SNMP WRITABLE 2.
1.
Press [Additional Functions].
2.
Press [ ] or [ ] to select <SYSTEM
SETTINGS>, then press [OK].
If the System Password has been set, enter the System Password
using the numeric keys, then press [OK].
TOP
Next
6-7