Connecting The Projector To The Computer; Connecting To Rgb Monitor Output Terminal (Analog Connection) - Canon REALiS WUX10 Mark II User Manual

Connecting the Projector to the Computer

Connect the projector to the computer.
Before connecting the cables, turn off both the projector and computer.
The digital connection (P38) is recommended when projecting a WUXGA or UXGA image
in high quality.

■Connecting to RGB Monitor Output Terminal (analog connection)

Supplied computer connection cable (Input signal type: [ANALOG PC-1] - P49)
Computer
Monitor output
terminal
(mini D-sub 15-pin)
Audio output terminal
(AUDIO OUT)
VGA cable (Input signal type: [ANALOG PC-2] - P49)
Computer
Monitor output
terminal
(mini D-sub 15-pin)
Audio output terminal
(AUDIO OUT)
• Use full connected VGA cable in which all pins are connected; otherwise, an image will be
projected improperly.
• Use an audio cable without a built-in resistor. Using an audio cable with a built-in resistor
turns down the sound.
Supplied computer connection cable
To input a corresponding
audio signal:
Commercial audio cable
Commercial VGA cable
To input a corresponding
audio signal:
Commercial audio cable
To AUDIO IN
To ANALOG PC-2/
COMPONENT IN
37
Connecting the Projector
Projector
To ANALOG PC-1/
DVI-I IN
Projector
To AUDIO IN