You Cannot Hear Sound - Canon REALiS WUX10 Mark II User Manual

Troubleshooting
Cause
The external monitor output is not
set on the notebook computer cor-
rectly.
The displayed image is not the
same as that displayed on the
computer.
The lens cap is not removed.

■You cannot hear sound.

Cause
The audio cable is not connected
correctly.
The MUTE function is enabled.
The volume level is adjusted to the
minimum.
An audio cable with a built-in resis-
tor is used.
Countermeasure
Turn on the external monitor output on the notebook com-
puter. To turn on the external monitor output, press the [LCD]
or [VGA] function key or a key with an icon for the external
monitor, while holding down the [Fn] key on the keyboard of
the notebook computer. (P46)
The combination of keys used to perform this operation varies
among computer manufacturers. For more detailed informa-
tion, refer to the User's Manual that came with your com-
puter.
Check whether the dual screen (multi-display) mode is
selected on the computer. If the dual screen mode has been
selected, change it to the simultaneous display mode on the
computer.
The output setting method varies among computer manufac-
turers. For more detailed information, refer to the User's Man-
ual that came with your computer.
Remove the lens cap.
Countermeasure
Check the cable connection of the audio cable. (P36)
Press the MUTE button on the remote control. (P67)
Press the VOL button on the remote control or the VOL+ but-
ton on the top control to adjust the volume level. (P67)
Use an audio cable without a built-in resistor.
120