Prohibiting The Projector Operation; Setting Up The Remote Control Channel - Canon REALiS WUX10 Mark II User Manual

Prohibiting the Projector Operation

[Key lock]
HDMI
DIGITAL PC
ANALOG PC
Key lock
You can prohibit the operation of the projector
from either the top control or remote control.
Off Disables the key lock.
Main unit Prohibit the operation from the
main unit.
Use the remote control.
Remote Prohibit the operation from the
control remote control.
Use the main unit.
Press the OK button to accept your setting
and then press the MENU button.
• [Off] is the factory default.
The key lock function becomes effective
from the moment the OK button is
pressed after selecting [Main unit] or
[Remote control]. Be sure to press the
OK button on the top control or remote
control which is not locked.
To Unlock Key Lock Function
Turn off the projector and unplug the power
plug. Hold down the OK button on the top
control and connect the power plug. Make
sure to keep holding down the OK button
until a beep sounds. The key lock is
unlocked.

Setting up the Remote Control Channel

[Remote control]
COMPONENT
VIDEO
System settings
You can set different channels to different
remote controls, if you use two projectors
at the same time.
Press the OK button to accept your setting
and then press the MENU button.
• The factory defaults is [Ch1] for both
• After changing the channel on the
Selecting a Channel on the Remote Control
You can change the channel on the
remote control as follows:
97
Setting Various Function
HDMI
DIGITAL PC
ANALOG PC
Remote control
Ch1 Select the channel of the remote control
used for this projector, and press the OK
Ch2 button.
projector and remote control.
menu, be sure to change the channel of
the remote control, too.
Ch1 Press the OK button and [ ] for 3 sec-
onds at the same time.
Ch2 Press the OK button and [>] for 3 sec-
onds at the same time.
COMPONENT
VIDEO
System settings