Replacing The Lamp - Canon REALiS WUX10 Mark II User Manual

Maintenance

■Replacing the Lamp

1
Turn off the projector, disconnect the
power plug from the AC outlet, and let
the projector stand for at least 1 hour.
2
Loosen a screw with a flathead screw-
driver and remove the lamp cover.
3
Loosen two screws, pull up the handle,
and then remove the lamp.
4
Fully insert a new lamp and secure it
with two screws.
* After the installation, be sure to
push down the handle.
5
Replace the lamp cover and tighten
the screw.
6
Turn on the projector.
7
Bring up the menu and select [System
settings] -> [Other settings] -> [Lamp
counter]. (P101)
8
Select [Reset] -> [OK] to reset the
lamp counter.
Handle
Lamp
126
Lamp cover
Screw
Screw
Lamp cover