Canon REALiS WUX10 Mark II User Manual page 19

When placing the projector on a castered stand or table, be sure to lock the
casters.
• Failure to do so may cause the projector to move or topple, resulting in an
Caution
injury.
Position the projector in a horizontal position.
• Install the projector correctly. Incorrect
installation may cause troubles and acci-
dents.
• Do not tilt the projector more than 20
degrees above and below the horizontal.
• When you want to use your projector point-
ing up or down, make sure to place the projector straight up or down.
• Do not install the projector vertically.
Do Not Use in the Following Environments
• Do not place the projector on an unstable or slanted surface. The projector
may fall causing a personal injury.
• Do not place it in an oily, smoky, or damp location (e.g., near a cooking table
or a humidifier). It may cause a fire or an electric shock.
• Do not place it near an exhaust outlet of air-conditioning equipment.
Do not install the projector in a humid or dusty location or a position where
there is a lot of oily or cigarette smoke. Optical parts such as a lens and mirror
may be stained, resulting in poor picture quality.
If the projector is carried from a cold place to a warm place or the room tem-
perature is raised rapidly, condensation may form on the lens and mirror due to
the moisture in the atmosphere, resulting in a blurred picture. Wait until con-
densation evaporates and normal picture is shown.
Do not use the projector in a place subject to either very high or very low tem-
peratures. Doing so may cause malfunction. The ranges of the operating and
storage temperatures are as shown below:
Operating temperature: +5°C to +35°C (Humidity: 85% or below)
Storage temperature: -10°C to +60°C
Using the Projector at 2300 Meters or More Above Sea Level
• If you use the projector at 2300 meters or more above sea level, the special
configuration is required to cool down the projector properly. Contact your
dealer.
20°
20°
19
Safety Instructions