Removing The Large Access Panel - HP Compaq 6000 Install Manual

Removing the Large Access Panel

To remove the large access panel:
1. If the workstation is on, turn it off and disconnect the power cord.
2. Disconnect any other external equipment.
3. Open the front bezel.
4. Loosen the two thumbscrews located on the left side of the front chassis
(see previous illustration).
5. Slide the large access panel toward the rear of the unit 0.5 inch (1.5 cm).
6. Lift and remove the panel.
CAUTION: Do not operate the workstation with the large access
panel removed. The large access panel is an integral part of the
cooling system and removing it while the system is running may
adversely affect data integrity.
Compaq Professional Workstation 6000 and 8000 Reference Guide
2-7