Table of Contents
Advertisement
3
Hardware changes
Warnings and cautions
Before performing upgrades be sure to carefully read all of the applicable instructions, cautions, and
warnings in this guide.
WARNING!
fire:
Energized and moving parts are inside. Disconnect power to the equipment before removing the enclosure.
Allow the internal system components to cool before you touch them.
Replace and secure the enclosure before re-energizing the equipment.
Do not plug telecommunications or telephone connectors into the network interface controller (NIC)
receptacles.
Do not disable the AC power cord grounding plug. The grounding plug is an important safety feature.
Plug the AC power cord into a grounded (earthed) AC outlet that is easily accessible at all times.
To reduce the risk of serious injury, read the Safety & Comfort Guide. It describes proper workstation setup
and provides guidelines for posture and work habits that increase your comfort and decrease your risk of
injury. It also provides electrical and mechanical safety information. This guide is located on the web at
http://www.hp.com/ergo.
CAUTION:
Before beginning the following procedures, be sure that you are discharged of static electricity by briefly
touching a grounded metal object. See
When the thin client is plugged into an AC power source, voltage is always applied to the system board. You
must disconnect the power cord from the power source before opening the thin client to prevent damage to
internal components.
Removing and replacing the access panel
Removing the access panel
WARNING!
fire, ALWAYS operate the thin client with the access panel in place. In addition to enhancing safety, the access
panel may provide important instructions and identification information, which may be lost if the access
panel is not used. DO NOT use any access panel except the one that is provided by HP for use with this thin
client.
Before removing the access panel, be sure that the thin client is turned off and the AC power cord is
disconnected from the AC outlet.
To remove the access panel:
1.
Remove/disengage any security devices that prohibit opening the thin client.
2.
Remove all removable media, such as USB flash drives, from the thin client.
3.
Turn off the thin client properly through the operating system, and then turn off any external devices.
16
Chapter 3 Hardware changes
To reduce the risk of personal injury or equipment damage from electric shock, hot surfaces, or
Static electricity can damage the electrical components of the thin client or optional equipment.
To reduce the risk of personal injury or equipment damage from electric shock, hot surfaces, or
Preventing electrostatic damage on page 27
for more information.
Hide quick links:
Advertisement
Table of Contents
