Laser Precautions; Rack Stability - HP Compaq 6000 Install Manual

Laser Precautions

!

Rack Stability

!
Any surface or area of the equipment marked with these
symbols indicates the presence of a hot surface or hot
component. If this surface is contacted, the potential for injury
exists.
WARNING: To reduce the risk of injury from a hot component,
allow the surface to cool before touching.
Power Supplies or Systems marked with these symbols
indicate the equipment is supplied by multiple sources of
power.
WARNING: To reduce the risk of injury from electrical
shock, remove all power cords to completely disconnect
power from the system.
WARNING: To reduce the risk of injury from laser radiation or damage to
the equipment, observe the following precautions:
Allow only Compaq Authorized Service Technicians to repair the
equipment.
Do not open any panels, operate controls, make adjustments, or
perform procedures to a laser device other than those specified
herein.
Do not stare into laser beam when panels are open.
WARNING: To reduce the risk of personal injury or damage to the
equipment, be sure that the leveling jacks extend to the floor and that the
full weight of the rack rests on the floor. Each rack should be level and
stable. Install stabilizing feet on a single rack or join multiple racks together
before starting work.
Compaq Professional Workstation 6000 and 8000 Reference Guide
xi