Quicklock/Quickblank - HP Compaq 6000 Install Manual

QuickLock/QuickBlank

QuickLock and QuickBlank are enabled through Security Management in
Computer Setup. The keyboard and mouse interface can be disabled and the
screen blanked from within an application. Entering a QuickLock key
combination (Ctrl+Alt+L) disables the keyboard and the mouse interface. If
QuickBlank is not activated, the application remains in view on the screen, but
it cannot be accessed.
To re-enable the input device interface and access the application, you must
enter the Power-On Password that you established in Security Management.
Therefore, you must establish a Power-On Password in order to utilize Quick
Lock and Quick Blank.
Enabling QuickLock and QuickBlank
To enable the QuickLock and QuickBlank features, the Power-On Password
must be enabled. Then:
1. Turn on the workstation.
2. When the cursor appears in the upper-right corner of the screen, press
F10. The cursor displays in the upper-right corner of the screen for
approximately two seconds. If you do not press F10 during this time,
you must turn the workstation off, then on again to access the utility.
3. Press Enter to bypass the welcome screens and display the main menu.
4. Select Computer Setup from the main menu and press Enter. The
workstation prompts you to reboot. Press Enter and the workstation
reboots into Computer Setup.
5. From the Computer Setup main menu, select the Security Management
feature under Built-In Devices.
Compaq Professional Workstation 6000 and 8000 Reference Guide
3-15