Hardware Installation Problems - HP Compaq 6000 Install Manual

8-10 Troubleshooting

Hardware Installation Problems

A new device is
not recognized as
part of the
system
Hardware Problems and Solutions
Problem
Computer Setup or the SCSI
software utility has not been
run to configure the new
device.
Cable(s) of new external
device are loose or power
cables are unplugged.
Power switch of new external
device is not turned on.
Table 8-6
Possible Cause Possible Solution
Run Computer Setup or the SCSI
software utility.
Ensure that all cables are properly
and securely connected and that
pins in the cable or connector are
not bent down.
Turn off the workstation, turn on
the external device, then turn on
the workstation to integrate the
device with the system.