HP Compaq 6000 Install Manual page 109

8-12 Troubleshooting
Network Problems and Solutions
Diagnostics
reports a failure.
Problem
Possible I/O address conflict
with another expansion
board.
The cable is not securely
connected.
The cable is attached to the
incorrect connector.
There is a problem with the
cable or a device at the other
end of the cable.
The network controller is
defective.
Network controller interrupt
overlaps the interrupt of an
expansion board.
continued
Possible Cause Possible Solution
Factory default is 300h to 30Fh
for Ethernet. Either remove and
reconfigure the conflicting
expansion board, or reconfigure
the network controller. If the
address is changed, ensure that
the drive parameters match the
new I/O address for the network
controller.
Ensure that the cable is securely
attached to the network
connector and that the other end
of the cable is securely attached
to the correct device.
Ensure that the cable is attached
to the correct connector.
Ensure that the cable and device
at the other end are operating
correctly.
Contact your Compaq authorized
service provider.
Run the Setup utility and modify
the network controller memory
value.
continued