Precautions For Products With Laser Devices; Laser Safety Warnings; Compliance With Cdrh Regulations; Compliance With International Regulations - HP MP4 User Manual

Precautions for products with laser devices

All HP systems equipped with a laser device comply with safety standards, including International
Electrotechnical Commission (IEC) 60825 and its relevant national implementations. With specific
regard to the laser, the equipment complies with laser product performance standards set by
government agencies for a Class 1 laser product. The product does not emit hazardous light; the beam
is totally enclosed during all modes of customer operation.

Laser safety warnings

In addition to the general precautions described earlier, be sure to observe the following warnings when
operating a product equipped with a laser device. Failure to observe these warnings could result in fire,
bodily injury, and damage to the equipment.
WARNING!
than those specified in the operators manual or in the laser device installation guide.
Allow only service partners to repair the laser equipment.

Compliance with CDRH regulations

The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration
implemented regulations for laser products on August 2, 1976. These regulations apply to laser products
manufactured from August 1, 1976. Compliance is mandatory for products marketed in the United
States.

Compliance with international regulations

All HP systems equipped with a laser device comply with appropriate safety standards including IEC
60825 and IEC 60950.

Laser product label

The following label or equivalent is located on the surface of your laser device. This label indicates that
the product is classified as a CLASS 1 LASER PRODUCT.
Do not operate controls, make adjustments, or perform procedures to a laser device other
Precautions for products with laser devices 59