HP ProCurve 4000M Installation Manual page 25

Hp procurve 4000m: install guide
Table of Contents

Advertisement

Insert the power supply into the
opening, lower it until it rests on the
bottom of the switch chassis, then
slide it all the way in until it connects
to the switch. The power supply
face plate will be flush with the back
of the switch.
Once the power supply is installed, make sure you tighten the four retaining
screws that hold it in place. The screws can be tightened with either a flat-
bladed or Torx T-10 screwdriver. Be careful not to overtighten the screws.
Installing the Switch 4000M and 8000M
Installation Procedures
tighten the four screws
2-7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ProCurve 4000M and is the answer not in the manual?

This manual is also suitable for:

Procurve 8000Procurve switch 4000mProcurve switch 8000mJ4121aJ4110a

Table of Contents