Block Diagram Of P30 - NEC UPD789426 Series User Manual

4.2.4 Port 3
This is a 4-bit I/O port with an output latch. Port 3 can be specified in the input or output mode in 1-bit units by
using port mode register 3 (PM3). When using the P30 to P33 pins as input port pins, on-chip pull-up resistors can be
connected in 1-bit units by setting pull-up resistor option register B3 (PUB3).
This port is also used as an external interrupt input, capture input, and timer I/O.
This port is set in the input mode when the RESET signal is input.
Figures 4-11 and 4-12 show block diagrams of port 3.
WR
PUB3
RD
WR
PORT
Output latch
WR
PM
PUB3: Pull-up resistor option register B3
PM: Port mode register
RD: Port 3 read signal
WR: Port 3 write signal
88
CHAPTER 4 PORT FUNCTIONS
Figure 4-11. Block Diagram of P30
PUB30
Alternate
function
(P30)
PM30
User's Manual U15075EJ2V1UD
V
DD
P-ch
P30/INTP0/CPT90