Table of Contents
Advertisement
5.4.2 Main system clock oscillator (RC oscillation) (mask option)
This oscillator is oscillated by the resistor (R) and capacitor (C) (4.0 MHz TYP.) connected across the CL1 and
CL2 pins.
An external clock can also be input to the circuit. In this case, input the clock signal to the CL1 pin, and leave the
CL2 pin open.
Figure 5-6 shows the external circuit of the main system clock oscillator (RC oscillation).
Figure 5-6. External Circuit of Main System Clock Oscillator (RC oscillation)
(a) RC oscillation
C
5.4.3 Subsystem clock oscillator
The subsystem clock oscillator is oscillated by the crystal resonator (32.768 kHz TYP.) connected across the XT1
and XT2 pins.
An external clock can also be input to the circuit. In this case, input the clock signal to the XT1 pin, and input the
inverted signal to the XT2 pin.
Figure 5-7 shows the external circuit of the subsystem clock oscillator.
(a) Crystal oscillation
Crystal resonator
Caution When using the main system or subsystem clock oscillator, wire as follows in the area enclosed
by the broken lines in Figures 5-5 to 5-7 to avoid an adverse effect from wiring capacitance.
• Keep the wiring length as short as possible.
• Do not cross the wiring with the other signal lines. Do not route the wiring near a signal line
through which a high fluctuating current flows.
• Always make the ground point of the oscillator capacitor the same potential as V
ground the capacitor to a ground pattern through which a high current flows.
• Do not fetch signals from the oscillator.
When using the subsystem clock, particular care is required because the subsystem clock oscillator is designed as
a low-amplitude circuit for reducing current consumption.
CHAPTER 5 CLOCK GENERATOR
CL1
R
CL2
V
SS
Figure 5-7. External Circuit of Subsystem Clock Oscillator
V
SS
XT1
32.768
kHz
XT2
User's Manual U15075EJ2V1UD
(b) External clock
External
CL1
clock
CL2
Open
(b) External clock
External
XT1
clock
XT2
. Do not
SS
109
Advertisement
Table of Contents
