Table of Contents
Advertisement
Firmware update
Important
• When you use this function, make sure the printer is connected to the Internet.
• The administrator password is required to change settings if it is enabled for changing settings using the
operation panel.
Using Operation Panel
1.
1. Tap
Home Screen Menu Composition
2.
2. Tap Printer settings.
3.
3. Tap Firmware update.
If an administrator password is set, enter the password.
4.
4. Tap Install update.
5.
5. Tap Yes.
6. Confirm displayed message and tap Start update.
6.
Using Remote UI
1. Start up Remote UI.
1.
Start up Remote UI
2.
2. Select Firmware update.
3. Select Install update.
3.
4. Confirm displayed message and select Update.
4.
Note
•
• If the firmware update is not complete, check the following and take an appropriate action.
Check the network settings such as a wireless router.
If Cannot connect to the server. is displayed on the touch screen, select OK and try again
after a while.
(Setup) on HOME screen.
354
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the imagePROGRAF GP-5300 and is the answer not in the manual?
Questions and answers