Table of Contents
Advertisement
Printing Hanging and Horizontal Banners (Large-Format
Printing)
A drapery or banner up to 18.0m can be made by enlarging or reducing original documents made on
application software.
However, there are cases in which an 18.0 meter banner cannot be printed because the application
software used has limits on the document size that can be set.
The procedure for printing hanging and horizontal banners is as follows:
Print for width of roll
1.
1. Create document by using application software
2.
2. Open the
printer driver setup window
3. Select the paper size
3.
Select the same original paper size created in the application soft in the Page Setup tab's Page Size.
In the event an optional size is set in the application software, select Custom Size from Custom
Paper Size in Page Size and
4. Select roll width
4.
Select the equivalent to the paper width of the roll set in the printer under Roll Paper Width.
5.
5. Set Enlarged/Reduced Printing
Check Enlarged/Reduced Printing and select Fit Roll Paper Width.
When the Information dialog box appears, select the equivalent to the paper width of the roll set in
the printer.
designate size
in the dialog box that appears.
451
Advertisement
Table of Contents
Troubleshooting
