Canon imagePROGRAF GP-5300 Online Manual page 535

Paper Source
Shows the source from which paper is supplied.
You may be able to switch the paper source with the printer driver.
Roll Paper
Feeds paper using roll paper.
Cut Sheet
Feeds paper using the cut paper.
Important
• Depending on the media type and size, the Paper Source settings that can be selected may differ.
Roll Paper Width
Select the roll paper width.
Select the width that matches the width of the roll paper loaded in the printer.
If you select Custom Size (XXXX), the paper size set in the printer will be used.
The paper information set in the printer can be confirmed in Get Information... in the Main sheet.
If you select User-defined1 (XXXX) or User-defined2 (XXXX), the
displayed, where you can specify the paper length and width.
Roll Paper Options...
Displays the Roll Paper Options dialog
You can specify auto cut, banner printing, and other settings for printing on roll paper.
Output Method...
Displays the Output Method dialog
You can select Output Method and specify save settings for saving documents to a box.
Size Options...
Displays the Paper Size Options dialog
The Paper Size Options dialog box allows you to create and register any user-defined paper.
Custom Size Settings dialog box (Paper Size)
This dialog box allows you to specify the size (width and height) of the custom paper.
Paper Size
Specifies the Width and the Height of the custom paper. Measurement is shown according to the
units specified in Units.
Units
Select the unit for entering a user-defined paper size.
Borderless Setting dialog box
Adjust how much of the document extends off the paper during borderless printing, and configure the
three-sided borderless setting.
Amount of Extension
Adjusts how much of the document extends off the paper during borderless printing.
Moving the slider to the right increases the amount of extension and allows you to perform borderless
printing with no problems.
box.
box.
box.
535
Custom Size Settings dialog box is