Vess A6000 Series NVR Server
1. Place the physical drive on a table with the bottom side facing up.
2. Position the drive in the carrier over the physical drive so the mounting holes line up (see below)
Note there are different mounting screw holes for 2.5" drives.
Drive carrier handle (front)
Bottom of 3.5" HDD
3. Insert the screws through the proper holes in the carrier and into the drive or adapter.
• Install four screws per drive.
• Snug each screw. Be careful not to over tighten.
4. With the drive carrier handle in open position, gently slide the drive carrier into the enclosure.
Important
Press the release button to push the drive carrier into position.
Proper drive installation ensures adequate grounding and minimizes
vibration. Always attach the drive to the carrier with four screws.
Mounting screws
Mounting screws (3.5" HDD)
18
Promise Technology
Screw holes for
mounting 2.5" SSD
or HDD