Viglen Vig560s Manual page 76

Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor Password
item on top of the screen shows the default Not Installed. After you set a password,
this item shows Installed.
To set a Supervisor Password:
1. Select the Change Supervisor Password item and press <Enter>.
2. From the password box, type a password composed of at least six letters and/or
numbers then press <Enter>.
3. Confirm the password when prompted.
The message "Password Installed" appears after you successfully set your
password.
To change the supervisor password, follow the same steps as in setting a user
password.
To clear the supervisor password, select the Change Supervisor Password then
press <Enter>. The message "Password Uninstalled" appears.
Note: If you forget your BIOS password, you can clear it by erasing the CMOS Real
Time Clock (RTC) RAM.
After you have set a supervisor password, the other items appear to allow you to
change other security settings.
Figure 59: Security Settings Sub-menu
User Access Level (Full Access)
This item allows you to select the access restriction to the Setup items. Configuration
options:
[No Access] [View Only] [Limited] [Full Access]
75
Vig560s Motherboard Manual