Problems Operating Add-In Boards - Viglen Vig560s Manual

Problems Operating Add-in Boards

Problems related to add-in boards are usually related to improper board installation
or interrupt and address conflicts. Go through the checklist below to see if you can
correct the problem. If the problem persists after you have checked and corrected all
of these items, contact the board vendor's customer service representative.
Did you install the add-in board according to the manufacturer's instructions?
Check the documentation that came with the board. Are all cables installed properly?
The following items are suggestions for troubleshooting problems related to PCI
legacy (non-Plug and Play) add-in boards.
• If the PCI board uses an interrupt, run Set-up and set the interrupt that is being
used by the PCI board to Used by PCI Card. Please refer to the BIOS manual for
details of how to do this.
• If the PCI legacy board uses memory space between 80000H - 9FFFFH, run Set-
up and set conventional memory to 256 K.
• If the PCI legacy board uses shared memory between C8000H - DFFFH, run Set-
up and enable shared memory for the appropriate memory space.
Vig560s Motherboard Manual
45