Table of Contents
Advertisement
S-ATA Connectors (7-pin S-ATA1, S-ATA2, S-ATA3, S-ATA4)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
Note:
• You must install Windows® 2000 Service Pack 4 or the Windows® XP Service
Pack1 before using Serial ATA hard disk drives.
•
When using the connectors in standard IDE mode, connect the primary (boot)
hard disk drive to the SATA1 or SATA2 connector. Refer to the table below for
the recommended hard disk drive connections.
Table 6: S-ATA Master/Slave Connectors
Connector
Colour
Red
S-ATA1, S-ATA2
S-ATA3, S-ATA4
Black
Figure 9: S-ATA Connectors
Setting
Use
Master
Boot Disk
Slave
Data Disk
Vig560s Motherboard Manual
26
Advertisement
Table of Contents
