Viglen Vig560s Manual page 48

Table 9: Problems and Suggestions (Continued)
What happens
Hard drive light does
not go on when drive
is in use or is tested
by POST
Power-on light does
not go on
Prompt doesn't
appear after system
boots
Setup, can't enter
System halts before
completing POST
What to do
Make sure the power and signal cables for the drive are properly
installed.
Make sure the front panel connector is securely attached to the
system board headers.
Check that the drive is properly configured and enabled in Setup.
Check the drive manufacturer's manual for proper configuration for
remote hard disk drive activity.
If the system is operating normally, check the connector between the
system board and the front panel. If OK, the light may be defective.
It's probably switched off.
A serious fault may have occurred consult your dealer service
department / Technical Support.
If you can't enter Setup to make changes, check the switch that
disables entry into Setup (Chapter 2). If the switch is set to allow
entry into Setup, you might need to clear CMOS RAM to the default
values and reconfigure the system in Setup.
This indicates a fatal system error that requires immediate service
attention. Note the screen display and write down any beep code
emitted. Provide this information to your dealer service department /
Technical Support.
Vig560s Motherboard Manual
47