Table of Contents
Advertisement
Table 5: Front Panel Audio Jumper Settings
Function
Jumper
Normal
5 – 6
and
9- 10
Table 5a: Front panel Audio Connector
Pin
Signal name
1
Audio Mic
3
Audio Mic Bias
5
Speaker Out
Right Channel
7
X
9
Speaker Out Left
Channel
USB Power Jumpers
USBPW56 & USBPW78 jumpers are set by default to +5V. Changing the jumpers to
the +5VSB will enable wake up from suspend with a USB device for the front USB
headers. This also applies for the rear USB ports with jumpers USBPW12 &
USBPW34 when set to +5VSB. If the desired mode of operation is to wake from
suspend with a USB device connected to the rear.
Keyboard Power Jumper
The Keyboard power jumper is set to +5VSB, this enables keyboard operation to
wake the system from suspend. If this is not desired set the jumper to +5V.
FAN Power Jumper
The FANPWR1 jumper should not be adjusted, the system is fitted with a CPU
Heatsink and FAN that uses PWM fan speed control. This is more stable than DC
mode and ensures the system runs with the lowest noise depending on the CPU
load.
CAUTION!
Do not move the jumper with the power on. Always turn off the power and unplug
the power cord from the computer before changing the jumper
Note:
There is no jumper setting for configuring the processor speed or bus
frequency.
Configuration
The audio line signals are routed back to the line connector.
Pin
Signal name
2
Ground
4
VCC
6
Speaker Out
Right Channel
Return
8
Key
10
Speaker Out
Left Channel
Return
Vig560s Motherboard Manual
.
22
Advertisement
Table of Contents
