Table of Contents
Advertisement
PCI IDE Connector (40-1 pin PRI_PCIIDE1)
This connector is for an Ultra DMA 133/100/66 signal cables. The IDE connector
supports up to two IDE devices (optical drive and hard disk drive).
Note:
• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra
DMA cable connector. This prevents incorrect insertion when you connect the
IDE cable.
• Use the 80-conductor IDE
•
The system automatically assigns the boot sequence of ATAPI devices
connected to the PCI IDE connector.
Figure 7: Floppy Drive Connector
cable for Ultra DMA 5 (ATA100/66) IDE devices.
Figure 8: PCI IDE Connector
Vig560s Motherboard Manual
25
Advertisement
Table of Contents
