Viglen Vig560s Manual page 30

Note:
• Do not forget to connect the 4-pin ATX +12 V power plug; otherwise, the system
will not boot up.
• To power the motherboard, it is recommended that you use an ATX 12 V
Specification 2.0 power supply unit (PSU) with a minimum 350 W power rating.
This PSU type has a 24-pin and 4-pin ATX power plugs.
•
If you intend to use a PSU with a 20-pin and 4-pin power plugs, make sure that
the 20-pin power plug can provide at least 15A on +12 V and that the PSU has a
minimum power rating of 350 W. The system may become unstable or may not
boot up if the power is inadequate. We do not, however, recommend the use of a
20-pin PSU.
•
You must install a PSU with a higher power rating if you intend to install
additional devices.
Optical Drive Audio Connector
This connector is for the 4-pin audio cable that connects to the audio connector at
the back of the optical drive.
Note: Enable the CD-IN function in the audio utility when using this connector.
Figure 13: Optical Drive Audio Connector
Vig560s Motherboard Manual
29