Henny Penny LVE-203 Technical Manual page 40

Program Code
T T - - 1 1 6 6
T T - - 1 1 7 7
T T - - 1 1 8 8
28
V V i i e e w w A A - - D D C C h h a a n n n n e e l l
D D i i g g i i t t a a l l I I n n p p u u t t s s
• "H" - HIGH LIMIT - If "H" is present, the high limit is good. If "-"
shows, then the high limit is tripped out (overheated) or
disconnected.
• "D" - DRAIN SWITCH - If "D" is present, then the drain handle (if
applicable) is closed. If "-" shows, then the drain is open or the
switch is faulty.
• "E" - ELEMENT SWITCH - If "E" is present, the element switch is
good. If "-" shows, then the element is in the upright position, or
the switch is faulty.
1 1 . . Press the right arrow and an "_" indicates the input is not
presently detected. A "✓" indicates the signal is detecting a
normal input. A blinking "X" indicates the signal is presently
detected, it is detected as a half-wave (partially failed) input.
NOTE: The H, D, E signals above are wired in series. The first signal
missing out of this sequence generally causes all signals to the right
of it to be missing as well.
A A I I F F I I n n f f o o
• "AIF ✓✓" - normal communications between the AIF PCB and the
control PCB and software is version 7.
• "AIF X" - A problem with the communication between the PCBs.
1 1 . . Press the down arrow and "FILR IN" "USE BY 1(ex)" shows in the
displays. These displays show which controls are using the
filtering system.
• "USE BY 0" - Not in use.
• "USE BY 7" - Used by AIF.
• "USE BY 1 to 5" - Used by control PCB.
2 2 . . Press the down arrow and "CPU POSN" "1 of 3(ex)" shows in the
displays. These displays show which controls are plugged into
which port on the AIF board. For example, the left control should
be plugged into port 1, and on a 3 control fryer, shows "1 of 3" on
the display. If the right control is unplugged, then the left control
would show "1 of 2" instead of "1 of 3".
3 3 . . Press the down arrow and "INP E_P_" & JL_R_DT_" shows in
displays.
A A I I F F B B o o a a r r d d I I n n p p u u t t s s
• "E" - Stop button.
• "E*" - E-Stop pressed.
Description