Henny Penny LVE-203 Technical Manual page 79

To reassemble, place rotor on drive shaft, and place roller into rotor.
3 3 ) )
NOTICE
7 7 . . 1 1 5 5 . . 2 2 R R e e s s e e t t t t i i n n g g T T h h e e r r m m a a l l O O v v e e r r l l o o a a d d S S w w i i t t c c h h
Open middle door, locate pump and motor above drain pan and if the motor is
1 1 ) )
hot, allow it to cool for about five minutes.
Since it takes some effort to reset the switch, use a tool, such as a Phillip's-head
2 2 ) )
screwdriver, to press against the reset button until an audible click is heard.
7 7 . . 1 1 5 5 . . 3 3 R R e e p p l l a a c c i i n n g g t t h h e e F F i i l l t t e e r r P P u u m m p p a a n n d d M M o o t t o o r r A A s s s s e e m m b b l l y y
Open the right door and remove JIB from fryer.
1 1 ) )
Open door to the left of the JIB and remove the drain pan.
2 2 ) )
Using a 1 inch wrench, disconnect the line at the elbow or tee on the front of the
3 3 ) )
pump.
Using a 1 inch wrench, disconnect the line at fitting on the rear of the pump.
4 4 ) )
T T h h e e r r e e i i s s a a n n i i n n d d i i c c a a t t o o r r o o n n t t h h e e s s i i d d e e o o f f t t h h e e
t t w w o o h h a a l l v v e e s s o o f f t t h h e e p p u u m m p p , , t t h h i i s s m m a a r r k k
m m u u s s t t b b e e t t o o g g e e t t h h e e r r . .
A small amount of grease might be
needed to hold the bottom roller into
place until cover plater is put on. Make
sure O-ring is in proper position on plate.
S S H H O O C C K K H H A A Z Z A A R R D D T T o o a a v v o o i i d d e e l l e e c c t t r r i i c c a a l l
s s h h o o c c k k , , m m o o v v e e t t h h e e p p o o w w e e r r s s w w i i t t c c h h t t o o o o f f f f a a n n d d
d d i i s s c c o o n n n n e e c c t t m m a a i i n n c c i i r r c c u u i i t t b b r r e e a a k k e e r r , , o o r r u u n n - -
p p l l u u g g c c a a r r d d a a t t w w a a l l l l r r e e c c e e p p t t a a c c l l e e . .
67