Henny Penny LVE-203 Technical Manual page 77

Trace wires from P12 on panel to vertical wall of controls area and separate
2 2 ) )
required connector.
From the rear of the fryer and using a 3/8 inch wrench, remove two nuts
3 3 ) )
securing seal clamp to drain trough studs.
Grasp drain valve and motor assembly, turn assembly 1/8 turn (45°) counter
4 4 ) )
clockwise (CCW) and slide assembly down so valve inlet clears vat drain tube.
Lift clamp up off of drain trough studs and maneuver valve and motor assembly
5 5 ) )
with lower drain tube attached from under fryer.
Remove shims, O-ring and clamp from lower drain tube.
6 6 ) )
Using large slip joint pliers, turn lower drain tube 1/8 turn (45°) counter clockwise
7 7 ) )
(CCW) and remove tube from valve.
Remove O-rings from inlet and outlet sides of valve body.
8 8 ) )
Using a 7/32 inch Allen wrench, loosen and unscrew two set screws until almost
9 9 ) )
removed.
Using a flat blade screwdriver, pry motor from valve body.
1 1 0 0 ) )
65