Henny Penny LVE-203 Technical Manual page 80

Using crosshead screwdriver, remove the rear cover from motor, exposing the
5 5 ) )
wires.
Loosen the conduit clamp, disconnect wires, and pull the wires through the
6 6 ) )
conduit clamp.
Using 7/16 inch wrench, remove three nuts, lockwashers, flat washers, spacer
7 7 ) )
washer sets, and bolts securing the motor to the motor bracket.
Pull the pump and motor assembly from fryer.
8 8 ) )
Reinstall pump and motor assembly following the above steps in reverse order,
9 9 ) )
however, leave assembly mounting bolts and nuts loose and perform position
adjustment after all electrical and plumbing connections are made.
7 7 . . 1 1 5 5 . . 4 4 R R e e p p l l a a c c e e P P u u m m p p O O n n M M o o t t o o r r
Using a 1/2 inch wrench, remove two bolts securing the pump to the motor and
1 1 ) )
pull the pump from the motor.
68