Teletek electronics MAG8P Installation And Operation Manual page 14

Fire Control Panel MAG8 - Installation and Operation Manual
sounders Enable / Disable
A sound signalization is activated at every service Mode entering. The
!
signalization is off by pressing "
Z
To disable the sounders:
• Press ENABLE/ DISABLE:
• Press TEST/ SCROLL, un-
til you reach the last zone in the
system:
• Press ENABLE/ DISABLE:
• Press RESET:
you can exit the sounder disabling mode also by pressing the "
button, as in that case the you reject the procedure.
Z
To enable the sounders:
• Press ENABLE/ DISABLE:
• Press TEST/ SCROLL, un-
til you reach the last zone in the
system:
• Press ENABLE/ DISABLE:
• Press RESET:
you can exit the sounder enabling mode also by pressing the "
button, as in that case the you reject the procedure.
14
sILENCE BUZZER" button.
DISABLE/ ENABLE LED blinks.
The ZONE 1 yellow LED blinks if ZONE 1 is en-
abled and lights permanently if ZONE 1 is disabled.
The SOUNDER FAULT/DISABLE LED will start
blinking.
The SOUNDER FAULT/DISABLE LED lights up
permanently.
The SOUNDER FAULT/DISABLE and ENABLE/
DISABLE LEDs light up permanently.
At this step the sounders are disabled.
DISABLE/ ENABLE LED blinks.
The ZONE 1 yellow LED blinks if ZONE 1 is en-
abled and lights permanently if ZONE 1 is disabled.
The SOUNDER FAULT/DISABLE LED lights up
permanently.
The SOUNDER FAULT/DISABLE LED will start
blinking.
At this step the sounders are enabled.
TEST/ SCROLL"
TEST/ SCROLL"