12. RS-232 Operation
Switch Port Command
The available formula for the Switch Port command is as follows:
Command + Control + [Enter]
For example, to switch to port 2, type the following:
sw i02 [Enter]
Note: The Control command can be skipped and the default value will be used.
12.4.7 Hotkey Setting
The Hotkey Setting command allows you to change the hotkey used to invoke the HSM (Hotkey Setting Mode).
The default hotkey is [Num Lock] + [-].
Use the Formula → to set Parameters → to create a Command.
Formula
Command + Control + [Enter]
Parameters
Command
hotkey
Control
num
f12
Enter
Enter
Hotkey Setting Commands
The available formulas for Hotkey Setting commands are as follows:
1
Command + Control + [Enter]
For example, to change the HSM invoke key to [Num Lock] + [-], type the following:
hotkey num [Enter]
2
Command + Control + [Enter]
For example, to change the HSM invoke key to [Ctrl] + [F12], type the following:
hotkey f12 [Enter]
Description
Hotkey Setting command
Description
Change the HSM invoke key to:
[Num Lock] + [-] (Default)
Change the HSM invoke key to:
[Ctrl] + [F12]
Description
Enter and send out command
50