Tripp Lite NetDirector B024-H4U16 Owner's Manual page 31

9. OSD Operation
Setting
Set User Login
Set Accessible Ports
Set Logout Timeout
Edit Port Names
Restore Default Values
Clear The Name List
Activate Beeper
Function
This function is used to set usernames and passwords for the administrator and users:
1. Usernames and passwords for one administrator and four users can be set.
2. After you select the administrator field or one of the user fields, a field that allows you
to key in the username and password appears. Usernames and passwords can be
from 1 to 16 characters long and can consist of any combination of letters and numbers
(A–Z, 0–9) and some additional keys (* ( ) + : - , ?. / space).
3. For each individual, key in the username and password, confirm the password, choose
SAVE, then press [Enter].
4. To modify or delete a previous username and/or password, use the backspace key to
erase individual letters or numbers. Press [Enter] when done.
Note: Usernames and passwords are not case sensitive. Usernames are displayed in capital letters
in the OSD.
This function allows the administrator to define user access to the computers on the
installation on a port-by-port basis.
For each user, select the target port, then press the [Spacebar] to cycle through the
choices: F (full access), V (view only) or blank. Repeat until all access rights have been
set, then press [Enter]. The default is F for all users on all ports.
Notes:
• A blank setting means that no access rights are granted. The port will not show up on the user's
LIST on the main screen.
• The administrator always has full access to all ports.
If there is no input from the console for the amount of time set with this function, the user
is automatically logged out. A login is necessary before the console can be used again.
This enables other users to gain access to the computers when the original user is no
longer accessing them, but has forgotten to log out. To set the timeout value, key in a
number from 1 to 180 minutes, then press [Enter]. The default setting of 0 disables this
function.
Note: This feature does not function if Set Login Mode is disabled.
To help remember which computer is attached to a particular port, every port can be given
a name. This function allows the administrator to create, modify, or delete port names.
To edit a port name:
1. Click the port or use the navigation keys to move the highlight bar to it.
2. Key in the new port name or modify/delete the old one. The maximum number of
characters allowed for the port name is 12.
Legal characters include:
• All alpha characters: A–Z
• All numeric characters: 0–9
• * ( ) + : - , ? . /
Case does not matter. The OSD displays the port name in all capitals, no matter how
they are keyed in.
3. When you have finished editing, press [Enter] to have the change take effect. To abort
the change, press [Esc].
This function is used to undo all changes and return the setup to the original factory default
settings (see 14.4 Factory Default Hotkeys and Settings), except for the port name list,
username and password information, which are saved.
This function clears the port name list.
Choices are Y (on), or N (off). When activated, the beeper sounds whenever a port is
changed, when activating the Auto Scan function (see 9.6.7 F7: Scan) or an invalid entry
is made on an OSD menu. The default is Y.
31