Tripp Lite NetDirector B024-H4U16 Owner's Manual page 19

7. Installation
Once you have finished cabling up (see section 7.3.2 Two-Stage Cascade Installation), power up according to the
following sequence:
1
For each Third-Stage unit, plug the power adapter cable into the switch's Power Jack, then plug the power adapter
into an AC source.
2
For each Second-Stage unit, plug the power adapter cable into the switch's Power Jack, then plug the power
adapter into an AC source.
3
Plug the First-Stage unit's power adapter cable into its Power Jack, then plug the power adapter into an AC source.
4
Power on the computers.
Notes:
• The Power On sequence requires that all Third-Stage units be powered on first. After they are all on, the Second-Stage units must
be powered on next. After the Second-Stage units are on, the First-Stage units must be powered on last. Only after all the switches
have been powered on in this sequence, can the computers be powered on.
• The USB 3.0 hub cannot be accessed through the switch by computers on the second or third level of a cascaded installation.
• Make sure the computers and devices that the B024-H4U08 / B024-H4U16 connects to are also properly grounded.
USB HDMI
KVM Cable Set
USB HDMI
KVM Cable Set
19