Tripp Lite NetDirector B024-H4U16 Owner's Manual page 42

10. Hotkey Operation
Key Function
[V] [n] [Enter] Sets EDID Mode.
• n = 1, read DisplayPort monitor's EDID.
• n = 2, default EDID mode (full HD 1920 x 1080 @ 60 Hz.
[P] [n] [Enter] Sets the KVM switching mode.
n = 1, sets the KVM to Normal Switching Mode.
n = 2, sets the KVM to Fast Switching Mode.
Note: This hotkey is only supported by B024-H4U08 / B024-H4U16 using firmware version v1.1.102
or later.
[M] Enables/disables mouse emulation.
[ ← ] Skips to the previous computer on the list while in Skip mode.
[ → ] Skips to the next computer on the list while in Skip mode.
[ ↑ ] Skips to the previous accessible port. If the previous accessible port has cascaded a switch, it skips
to the last accessible port of that switch.
[ ↓ ] Skips to the next accessible port. If the next accessible port has cascaded a switch, it skips to the
first accessible port of that switch.
[ESC] or Exits hotkey setting mode (HSM).
[Spacebar]
Note: Enable mouse emulation to perform any independent switching of a port and for Auto Scan Mode or Skip Mode to work (see
10.14 Mouse Emulation Control).
42