Commands; Verification; Login - Tripp Lite NetDirector B024-H4U16 Owner's Manual

12. RS-232 Operation
12.4 RS-232 Commands
After you login via HyperTerminal (see 12.3 Console Login: HyperTerminal), use the instructions below to send
RS-232 commands to control the switch from the computer.
When RS-232 control is enabled via the Open + [Enter] command, the KVM's front panel pushbuttons, OSD, hotkeys
and remote control commands will be disabled until the RS-232 control is disabled.

12.4.1 Verification

After entering a command, a verification message appears at the end of the command line:
Response Message
Command OK
Command incorrect
With all commands in the sections that follow:
• Each command string can be separated with a space.
• The [Enter] command can be replaced with the ASCII code: 0x0D0A

12.4.2 Login

The Login command allows you to log in to the KVM and send RS-232 commands. When you log in, the RS-232 link is
"opened" and the KVM will not respond to front panel pushbuttons, hotkeys, OSD or remote control commands until the
RS-232 link is closed (see 12.4.6 Switch Port).
Use the Formula → to set Parameters → to create a Command.
Formula
Command + Control + Name + Number + [Enter]
Parameters
Command
login
Control
U
Name
xxxxxxxxxxxxx
Password
xxxxxxxxxxxxx
Enter
Enter
Login Command
The formula for the Login command is as follows:
Command + Control + Name + Number + [Enter]
For example, to login via username and password, type the following:
login u administrator p12345 [Enter]
Description
Command or parameter is correct.
Command or parameter is incorrect.
Description
Login command
Description
Input user name + password
Description
The login user name
Description
The login user password
Description
Enter and send out command
47