8. Hotkey Operation
8.12 Disable Port Switching Keys
To disable the Port Switching Keys ([Scroll Lock] [Scroll Lock] / [Ctrl] [Ctrl]):
1. Invoke Hotkey Mode.
2. Press [X] [Enter].
Note: This procedure is a toggle. To enable the Port Switching keys, repeat steps 1 and 2.
8.13 Firmware Upgrade Mode
To set the B006-VU4-1 to Firmware Upgrade Mode:
1. Invoke Hotkey Setting Mode.
2. Key in: upgrade
3. Press [Enter].
All front panel LEDs (green and orange) flash to indicate Firmware Upgrade Mode is in effect.
Note: To exit Firmware Upgrade Mode, you must power off the switch.
8.14 Restore Default Settings
To reset the B006-VU4-1 to its default hotkey settings:
1. Invoke Hotkey Setting Mode.
2. Press [R] [Enter].
See Hotkey Default Settings section for additional details.
8.15 Mouse Port-Switching
To enable/disable the Mouse Port-switching function, do the following:
1. Invoke Hotkey Setting Mode.
2. Press [W].
Notes:
• This procedure is a toggle.
• The default setting is disabled.
• The feature is only supported when mouse emulation is enabled.
8.16 Mouse Emulation Control
To toggle between mouse emulation enable and disable:
1. Invoke Hotkey Setting Mode.
2. Press [M].
8.17 Keyboard Emulation Control
To toggle between keyboard emulation enable and disable:
1. Invoke Hotkey Setting Mode.
2. Press [N].
Note: When keyboard emulation is disabled, the [m], [w], [F2], [F3], [F10], [F4], [F5], and [F6] hotkeys are disabled.
14