Set Park Action; Set Privacy Mask - HIKVISION DS-2TD4137-25/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual

8.9 Set Park Action

You can set the device to perform an action (for example, preset or patrol) or return to a position
after a period of inactivity (park time).
Before You Start
Set the action type first. For example, if you want to select patrol as park action, you should set the
patrol. For setting patrols, refer to Set Patrol Scan .
Steps
1. Go to Configuration → PTZ → Park Action and check Enable Park Action.
2. Set Park Time, the inactive time before the device starts the park action.
3. Select Action Type according to your needs.
4. Click Save.

8.10 Set Privacy Mask

Privacy mask enables you to cover certain areas on the live image to prevent certain spots in the
surveillance area from being live viewed and recorded.
Steps
1. Go to Configuration → PTZ → Privacy Mask .
2. Adjust the live image to the target scene via PTZ control buttons.
3. Draw the area.
Draw Area
Stop Drawing
4. Click Add.
It is listed in Privacy Mask List.
5. Edit Name, Type, and Active Zoom Ratio on your demand.
Active Zoom Ratio
When the actual zoom ratio is less than the set active zoom ratio, the set area can not be
covered. When the actual zoom ratio is greater than the set active zoom ratio, the privacy
mask is valid. The maximum value of active zoom ratio depends on the camera module.
6. Repeat the steps above to set other privacy masks.
7. Check Enable Privacy Masks.
Click Draw Area, and click on the live view
image to determine the boundary of the
mask.
ClickStop Drawing after drawing the mask.
41