Set Thermography Parameters - HIKVISION DS-2TD4137-25/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual

3.3.1 Set Thermography Parameters

Configure the parameters of temperature measurement.
Before You Start
Go to Configuration → System → Maintenance → VCA Resource Type , select Temperature
Measurement+Behavior Analysis.
Steps
1. Go to Configuration → Local , enable Display Temperature Info. .
Display Temperature Info.
Select Yes to display temperature information on live view.
Display Temperature Info. on Capture
Select Yes to display temperature information on the capture.
Display Rule Info. on Capture
Select Yes to display rule information on the capture.
Enable Rules to display the rules information on live view.
2. Click Save.
3. Go to Configuration → Temperature Measurement → Basic Settings to configure parameters.
Enable Temperature Measurement
Check to enable temperature measurement function.
Enable Color-Temperature
Check to display Temperature-Color Ruler in live view.
Display Temperature Info. on Stream
Check to display temperature information on the stream.
Display Max./Min./Average Temperature
Check to display maximum/minimum/average temperature information on liveview when
the temperature measurement rule is line or area.
Position of Thermometry Info
Select the position of temperature information showed on the live view.
• Near Target: display the information beside the temperature measurement rule.
• Top Left: display the information on the top left of screen.
Add Original Data on Capture
Check to add data on alarm triggered capture of thermal channel.
Add Original Data on Stream
Check to add original data on thermal view.
Data Refresh Interval
It means the refresh interval of temperature information.
7