Set Linear Scan; Set Limit - HIKVISION DS-2TD4137-25/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Note
If you need to delete all the pattern scans, go to Configuration → PTZ → Clear Config , and
check Clear All Patterns, and click Save.

8.5 Set Linear Scan

The device can perform auto scan in setting area for fire source detection.
Steps
1. Go to Configuration → PTZ → Linear Scan .
2. Select the camera channel.
3. Zoom in and zoom out the camera to the appropriate zoom ratio, and click Save Ratio.
Note
Click Enable Saved Ratio to set the camera to the saved zoom ratio.
4. Check Enter Area Settings.
5. Set the left/right/up/down limits with the PTZ control panel, and click
6. Optional: Click Clear to delete the saved scan area.
7. Click Save.
8. Click Call Linear Scan to start linear scan, and click Stop Linear Scan to stop linear scan.
Note
When setting the linear scan area, make sure the target area is both included in the optical
channel and the thermal channel.

8.6 Set Limit

The device can only move within the limited range.
Steps
1. Go to Configuration → PTZ → Limit .
2. Select Limit Type.
Manual Stops
It refers to the movement range limit when you control the device manually.
Scan Stops
It refers to the movement range limit when the device scans automatically.
Note
Scan limit is only supported by the device that has scan function.
39
to confirm settings.