Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Line Crossing
If any target move across the setting line, the alarm will be triggered. You can set the crossing
direction.
Intrusion
If any target intrude into the pre-defined region longer than the set duration, the alarm will
be triggered.
Region Entrance
If any target enter the pre-defined region, the alarm will be triggered.
Region Exiting
If any target exit the pre-defined region, the alarm will be triggered.
4. Set parameters of the rule.
- Sensitivity
The higher the value is, the easier the alarm can be triggered.
Detection Target
You are recommended to select the target as Human & Vehicle. In distant view, the device
cannot classify the target with pixels less than 10*10. The target will be recognized as
human directly. So the selection of this item will not trigger false alarm or missing alarm.
Background Interference Suppression
Eliminate the environment interference to reduce the false alarm. For example, the wind
blow grass.
5. Draw the rules.
- When the rule type is selected as Line Crossing, click
can drag end points of the line to adjust the position and length.
Line Crossing
You can set the crossing direction. Bidirectional, A-to-B, or B-to-A are selectable.
- When the rule type is selected as Intrusion,Region Entrance, Region Entrance, click
draw an area in the live view. Right click the mouse to finish drawing.
Duration
The device performs behavior analysis when the target stays in the detection area for
more than setting value.
Note
Draw three segments of the rule from near to far to cover all of the detection area.
6. Check to enable Filter by Pixel. Then Draw max size and min size rectangles to filter the target
among human, vehicle, animal, and others. Only the target whose size is between the Max. Size
and Min. Size value will trigger the alarm.
to draw a line in the live view. You
21
to
Advertisement
Table of Contents
